arlingt374

2" Aluminum entrance cap, clamp on type for rigid IMC and EMT. Hole Sizes 2 at .75 and 3 at 1.0 and 1 at .53.

1-Hole Steel Strap for service entrance cable, accepts 3/0 to 4/0 wire range.

1-1/2" 1-Hole Rigid Strap, Snap on type, plated steel.

1-1/2" 2-Hole Rigid Strap, Snap on type, plated steel.

2" 2-Hole Rigid Strap, Snap on type, plated steel.

2" 2-Hole EMT Strap, Click on type, plated steel

Duplex zinc die-cast, 3/8" Knockout MC cable connector snaps quickly on to the conduit with an internal spring steel clip and then snaps into knock...

1" x 3/4" Hex head reducing bushing, zinc die-cast, maintains ground path and able to pass ul high current testing.

2 screw clamp type. zinc die-cast. Maximum opening of .900. For one NM or service entrance cable.

Zinc die-cast, single screw duplex connector with a 1/2" knockout secured by locknut. Concrete tight when taped.

Nail in cable support keeps cables away from the nailing surface while supporting up to four 14/2 to 10/2 and two 14/3 to 10/3 NM cables, sold in p...

EMT Insulating bushing, press fit, holds firmly in place while pulling cables. Trade Size 1".

Zinc die-cast, 1/2 Knockout, Screw in connector for aluminum and steel cable. Secures to knockout with zinc die-cast locknut. Up to 1/2" cable.

Combination 90 degree pulling elbow for threaded rigid and set screw EMT with cover and gasket, Zinc die-cast. Trade Size 3/4".

Zinc die-cast, Single screw, 1-1/4" knockout squeeze connector with round end stop. For Flex, AC, MCI cable. Concrete tight when taped. End stop di...